TE180 - Advanced microprocessor control unit

MAIN FEATURES

• 15 welding programs selectable by keyboard and by an external device.

• 16 programmable parameters

• Control of 3 solenoid valves 24 Vdc 7,2 W Max with protected output against short circuit

• Display of the welding current in kA

• Counter of the performed welds

• Output of endcycle with relay, also selectable as interlock

• Minimum and maximum limit of the welding current for each program

• Output signal for out-of-limits spots with relay

• Automatic compensation against voltage drops

• Stepper function against electrodes wear

• Restart key and outputs enabling under Watch-dog control

• Serial communication by means of insulated RS-232 interface (optional)

• Removable key for programming or for run.

• Integrated ammeter with four different capacities to select (18,36,45,90 kA)

• Key to select foot control or two hands control

• Possibility to eliminate the autoretain of the start signal during the welding process

• Self-adjustment to the network frequency 50/60 Hz

PROGRAMMABLE PARAMETERS

PARAMETER	RANGE
1° SQUEEZE	01 - 99 cycles
SQUEEZE	00 - 99 cycles
FORGE DELAY	00 - 99 cycles
SLOPE UP	00 - 29 cycles
WELD TIME 1	01 - 99 cycles
CURRENT 1	01 - 99 %
COLD TIME 1	00 - 50 cycles
IMPULSE N.	01 - 09
SLOPE DOWN	00 - 29 cycles
COLD TIME 2	00 - 50 cycles
WELD TIME 2	00 - 99 cycles
CURRENT 2	00 - 99 %
HOLD TIME	01 - 99 cycles
OFF TIME	00 - 99 cycles
MIN. CURR.	0 - 90 kA
MAX. CURR.	0 - 90 kA

 

Specifications subject to change without notice.